| Sign In | Join Free | My burrillandco.com |
|
Make best lean solution for client
8 Years
| Ask Lasest Price | |
| Brand Name : | Diya |
| Model Number : | series |
| Certification : | ISO9001 |
| Price : | USD78-499 per set |
| Supply Ability : | 100000 meters per month |
| Payment Terms : | Western Union, L/C, T/T, MoneyGram |
| Delivery Time : | 5-25 days |
FIFO Lean Pipe rack storage system with colored pipe storage
A. first installed the side plate and the bottom plate to install
the connecting rod.
B. reloading a load-bearing rod and installing a connecting rod.
C. is then installed in the middle of the two ends, and all chuck
and plastic pipes are installed in accordance with the design
requirements.
D. finally to ensure that each clamp screws in place, can not use a
hard hammer to beat the plastic pipe and the chuck, when installing
the column to ensure that vertical to the ground, so that the whole
lean pipe rack unevenly force to cause damage. (Note: when cutting
the clad pipe, note that the cutting deformation of the plastic
pipe may have special purpose components, such as insert frame,
hook, etc., which needs to be machined and configured).
Then understand the design points of lean pipe shelves.
When the load is considered in design, the strength can be
increased through the addition of fulcrum, connectors and parallel
use of double clad pipe. When designing the structure, it is
recognized that the main load is directly acting on the fittings,
not on the connecting parts. The maximum horizontal distance is
600mm, and there must be vertical support to the ground. And every
1200mm, the vertical column should go directly to the ground. For
products with casters, the underframe should be a two bar parallel
structure. The horizontal distance is 600mm, and the safety load of
single bar and slide is 30kg. A whole coating is stronger than a
few cladding tubes connected by the chuck, so when the plastic pipe
is selected, the force must be the whole root and the connecting
rod can be segmented. The width of each row (center distance) of
the sliding rack is the width of the turnover box +60mm, and the
height of each layer is +50mm of the turnover box. The inclination
angle of the slideway is determined. The inclination angle of the
general slide is 5 - 8 degrees. The inclination should be smaller
when the fine material, heavy material and the bottom end of the
turnaround box are measured.
|
|
